VivaFPV 45A 4 in 1 ESC Combining the VivaFPV 4in1 ESC with the F4 FC provides an economic powerhouse to any kind of FPV application. Plug and play compatibility with many FC's, insane raw power, unbeatable price. Do you need more reasons? DShot 1200, 60A, 3-6S!
- Input voltage: 3-6S
- Burst current: 60A
- Constant current: 45A
- Input protocols: OneShot42, Multishot, DShot 1200
- Mounting holes: 30.5 x 30.5mm
- Firmware: BLHeli32 Suite (VIVAFPV_45A_BL32)
- Connector: JST SH 1.0mm
- Weight: 16g
- BEC: 3A / 5V
- Plug and play with the VivaFPV FlightController
- VivaFPV 4in1 60A ESC x 1
- FC Connector Wire x 1
- XT60 Power Cable x 1
- 470uF 35V Low ESR Capacitor x 1
The VivaFPV 45A 4 in 1 ESC was chosen to replace a dead Wizard ESC primarily because it includes a 5V BEC which is required for the motor lights on the Wizard. The VivaFPV 45A 4 in 1 ESC has higher current rating than the original and feels really well made. You will need a good soldering iron particularly for the battery terminals. Even with a large tip my Hakko iron struggled to deliver the heat the power plaines in the board could absorb. The 10pin cable to the FC was not compatible and the FC end plug was cut off. The individual signals were broken out and soldered to the appropriate pads on the the Omnibus v3 FC. The Wizard had to be changed from DSHOT600 to 1200 before all the motors would spin. We don't have BLHelli configurator working yet but as we didn't need to reverse any motor spin we have not resolved that. Some of the slots in the sides of the Wizard need to be enlarged with a nibbling tool as the connectors were larger and battery connector not contained within the square. All up we were very pleased with the VivaFPV 45A 4 in 1 ESC. The pilot repots that flight seem smoother with the new esc.